Service manual

6
c. Grasp the adjusting knob in
one hand and hold it
stationary, as you unscrew the
body of the valve itself 5 - 6 full
turns.
d. Hold the knob still, and turn
the silver lock ring all the way in
(clockwise), locking the adjusting knob in
place.
6) Screw the new flow control valve into the
hole in the cutting head nearest the
cutting board, where the small ¼” brass
fitting was mounted initially. (Since this
valve works with the opposite air flow
direction as the original valve, it must be
mounted into the opposite side of the
cutting head air cylinder).
Use the 5/16” nut driver to tighten the
valve securely into the cutting head. Turn
C.
D