Service manual

8
16) Remove the flat-head bolt
from the squaring adjustment
tab on the bottom left of the
gantry with a 5mm Allen
wrench. Do not loosen or
remove the adjusting bolt at
this time.
17) Pry the yellow plastic strips from the slots
in the front side of the Y-gantry extrusion
in order to access the four gantry
mounting bolts. Remove the bolts with a
6mm Allen wrench, and carefully remove
the gantry assembly from the machine
with assistance from another person, if
needed. Lay the gantry down flat on a
suitable work surface.