Service manual

6
13) Remove the motor mounting
plate from the upper reversing
unit by removing the 3 M5
bolts. Do not lose the captive
lock nuts from the rear when
removing these bolts.
14) On the back (cutting board), side of the
Y-gantry, disconnect the wires to both
upper and lower limit switches. Note the
wire locations on the switch terminals prior
to removing. Do not loosen or remove the
switch or sensor mounting brackets at this
time.
15) Cut any cable ties holding the wires to
the back of the gantry, and pry the
yellow plastic strip from the rear slot to
allow the home and limit wires to be
freed from the extrusion. Disconnect the
Y-home sensor cable plug as well.
Cut top cable tie