Service manual

4
10) Loosen the four motor
mounting bolts, and remove
the Y-axis motor belt.
11) Remove the motor mount nuts
and bolts completely, and carefully
remove the Y-axis motor from the
rear of the mounting plate.
12) If a new large-diameter
pulley and motor
mounting plate have
not been supplied, you
must now remove the
pulley from the
reversing unit shaft.
Loosen the two set
screws with a 1/8”
Allen wrench and pry
the pulley from the
shaft. A “gear puller”
tool may be used, if
necessary. (see
below)