Service manual

2
4) Follow the “Removing the Cutting Head”
procedure. Remove the cutting head
mounting plate as well, using a 5mm Allen
wrench to remove the four flat-head M5
bolts. Mark the top edge of the plate prior
to removal.
5) Mark the location of the Y-home
magnet bracket onto the upper bearing
wipe assembly. Remove the magnet
bracket from the bearing wipe assembly.
(5/32” Allen wrench).
6) Remove both top and bottom bearing
wipe assemblies from the Y-axis bearing
cart using a 3mm Allen wrench. Slide the
cable tie(s) and wires off the end of the
mounting post(s).
Mark Top edge of plate
and remove 4 bolts