Service manual

9
8) Mount the new adapter block to the bearing cart with the four M5 bolts, align it with
the bearing cart, and tighten the bolts securely.
9) Replace the single M5 bolt from the adapter block to the belt coupling, and tighten it
securely.
10) Replace the X-sensor magnet onto the right side of the adapter plate. Position the
bracket so that there is ¼” of vertical distance between the magnet and the X-axis
home sensor.
11) Replace the cable carrier bracket to the
adapter block, and the carrier to the
bracket.
12) Repeat the procedure for the lower
adapter plate in the same manner. (no
cable hardware or sensor magnet is
present.
Rear View of X-axis home sensor
and magnetic actuator - 1/4” of
vertical space between
Magnet
X-axis sensor
¼” distance
End view of X-axis sensor and magnet