Service manual

7) Orient the new reversing unit

properly (pre-drilled sensor

bracket hole is toward top-rear),

and thread the belt back through

it. Use a steel ruler or other tool

to aid in bending the belt through

the internal pulley.

8) Mount the new reversing unit onto the frame with the existing hardware. Tighten the

front and rear universal (recessed), bolts securely.

9) Re-couple the end of the

belt into the coupling

hardware. Tighten the

tension bolts until the

distance of the protruding

ends matches the original

measurement (step 3)

Proper location of belt wedge in coupling