Service manual

Replacement of Y- Axis Bearing Cart

1) Turn off power to the F-6100, and disconnect the main air hose from the rear of the

machine.

2) Remove the cutting head; follow “Cutting Head Removal” procedure.

3) Mark the top edge of the cutting head mounting plate with a pencil, then remove the

4 flat head bolts with a 5mm Allen wrench. Note: check for any shim washers behind

the mounting plate, and note the location(s).

4) Remove both top and bottom

bearing wipe assemblies by

removing the 3 screws with a

3mm Allen wrench. (Remove the

Y-axis home sensor magnet

bracket from the top wipe

assembly first, and mark its

location) Slide the cable ties and

wires off the mounting posts.

5) Remove the cable carrier L-

bracket from the front of the

bearing cart by removing the

two bolts with a 5mm Allen

wrench. Move the cable

chain/carrier out of the way

to your left.

Remove Y-home magnet bracket from here first