Service manual

3
7) Mark the location of the top-right
(from front), bumper bracket onto
the frame extrusion with a pencil.
Remove the bumper bracket with
a 5mm Allen wrench.
8) Remove the vertical torque rod housing from the right side of the machine (as seen
from the front). Remove the fasteners from bottom to top: Philips screw, 5/16” hex
screw, and then the top 5mm Allen bolt. Slide the entire housing off the frame to the
right.
9) Remove the two nuts from
underneath the top of the X-axis
cable carrier chain, using a 3/8”
wrench.(rear of machine) You may
need to hold the heads of the
screws stationary from above with a
1/8” Allen wrench. Slide the entire
cable chain upward and off the
cable carrier bracket. Remove the
carrier bracket by removing the two
screws with a 5/32” Allen wrench.
Mark bracket location here