Service manual

9
5) Remove the flat head bolt from the
squaring adjustment tab on the left
side of the gantry. (5mm Allen) Do
NOT loosen or remove the squaring
adjustment bolt or locking nuts. (see
photo)
6) Remove the 4 mounting bolts on the
rear of the bearing cart adapter
plate with a 5mm Allen wrench. (see
photo) Do not loosen or remove the
bolt that mounts the drive belt
coupling to the adapter plate.
7) Place a small piece of mat or
foam board (~3 5/8” wide),
between the gantry beam and
the cutting board surface. This
will support the lower end of
the gantry and help prevent
excessive flexing of the top
cart bearings while the lower
cart is removed.