Service manual

and raise the cutting head upward at least 18”. Make sure that the X and Y axis

motor cables are disconnected from the electronics controller first.

2) Remove the urethane bumper, spring, and plastic guard strip as in step 2 above.

Then loosen the bolt at the lower end

of the cable channel with a 5mm Allen

wrench, as shown. Do not remove the

bolt entirely.

3) Remove both the left and right side felt

pad holders from the bearing cart by

removing the 3 Allen screws from each. (3mm

Allen wrench)

4) Pry the two yellow plastic molding strips outward, as shown, in order to access the

lower gantry mounting bolts. Remove both bolts with a 6mm Allen wrench.