Service manual

3
5) To remove the top felt pad holder assembly
from the bearing cart, first trace the location
of the Y-axis Home magnet bracket onto the
black surface with a pencil. This will aid in
locating the magnet in the precise position
when re-assembling.
Remove the Y-axis magnet bracket by
removing the single screw with a 5/32” Allen
wrench.
6) Then remove the 3
screws from the pad
holder with a 3mm
Allen wrench, as
shown. Lift the pad
holder assembly off
to the right, as
shown. You may
remove the lower felt
pad holder as well.