Service manual

2
3) Remove the 4 mounting bolts from
the cutting head with a 5/32” Allen
wrench, as shown. Retract the cutting
head glide pad from the slip sheet
surface, and remove the head by
pulling straight to the right. Be careful
not to bend or damage the two
locator pins on the head mounting
plate when removing.
4) Carefully remove the 4 cutting head
mounting plate bolts with a 5mm Allen
wrench. Be aware that there may be one or
more thin “shim” washers placed between
the mounting plate and bearing cart
surfaces. If present, these washers must be
placed in the same location(s) when
remounting the head afterwards. Tip: Mark
the location(s) of any shim washers, and the
top edge of the mounting plate with a pencil.
This will aid in re-mounting the plate in the
correct orientation afterwards.