Service manual

9
screws have
usually caused
deformation of the
shaft itself. If
available, you may
use a “gear puller”
type tool to aid in
removal. (see
photos) Gear Puller
tools are available
at most Auto Parts
stores.
4) Clean the shaft of
any residual Loctite
with steel wool or
fine emery cloth.
Mount the
replacement pulley
onto the shaft,
taking care to
radially align one pulley set screw to the flat surface of the motor shaft (see
diagram above), or to the notch or spline or the shaft. (see below). Measure the
pulley distance between the pulley and motor plate (~3/8”), making sure that it is
aligned with the other pulley.
Gear / Pulley “Puller” tool. Align pusher bolt with center of shaft.
Ti
g
hten Pusher bolt to
g
raduall
y
remove pulle
y
from shaft.