User's Manual

1800MHz-1900MHz Off-Air Repeaters (OR Series) Page 91 080 0701F – Rel.04
CHAPTER 4
4.5
4.2) POWER-UP
Warning: before power up, make sure that the isolation between the donor antenna and the
service antenna is at least 15dB greater than the repeater gain.
1. Connect the cable from the donor antenna to a spectrum analyzer and check input signal presence and
level. After measurement disconnect the spectrum analyzer.
2. Switch on the equipment by means of the switches placed inside the repeater (FIGURE 1a and b).
3. Check the LEDs status on the management module: FIGURE 4 and Table 3 show LEDs status on the
management module under normal operating conditions.
FIGURE 4 – MANAGEMENT MODULE: LEDS STATUS - CORRECT POWER UP
REF. STATUS MEANING
LED 1S OFF
LED 2S ON
Equipment correctly operating
LED 3S ON Management module: +5Vdc available
LED 4S ON, GREEN
HPA (High Power Amplifier) - UP LINK -
communicates with management module
LED 5S ON, GREEN
HPA (High Power Amplifier) - DOWN LINK -
communicates with management module
LED 6S ON, GREEN
LNA (Low Noise Amplifier) - DOWN LINK -
communicates with management module
LED 7S ON, GREEN
BS1 communicates with management module
LED 8S ON, GREEN
BS2 communicates with management module
LED 9S ON, GREEN
LNA (Low Noise Amplifier) - UP LINK - communicates
with management module
LED 10S ON, GREEN 132kHz correctly operating
LED 11S OFF
NO Return Loss alarm
TABLE 3 - MANAGEMENT MODULE: LEDS STATUS - CORRECT POWER UP
11S
1S 2S 4S3S 5S
U
U
RL
OPERATING
+5V
ALARM
132KHz
DLNA
HPA D
BS 2
BS 1
6S10S 9S 8S 7S