User's Manual
Table Of Contents
- 900MHz ADJUSTABLE BANDWIDTH OFF-AIR REPEATERS_91 080 0716F
- INDEX
- 1) SAFETY RULES
- 2) STANDARDS
- 3) GENERAL DESCRIPTION
- 3.1) EXAMPLE: USE IN TUNNELS
- 3.2) OPERATING PRINCIPLE - 800MHz/900MHz ADJUSTABLE BANDWIDTH OFF-AIR REPEATERS
- 3.3) ATTACHED DOCUMENTS
- SMR - TECHNICAL CHARACTERISTICS
- CDMA/TDMA/AMPS - TECHNICAL CHARACTERISTICS
- EGSM - TECHNICAL CHARACTERISTICS
- GSM-R - TECHNICAL CHARACTERISTICS
- CDMA/TDMA/AMPS - ILLUSTRATIVE 1 - Equipment composition and backplane access points map
- CDMA/TDMA/AMPS - ILLUSTRATIVE 2 - Modules access points map and external access points map
- EGSM - ILLUSTRATIVE 1 - Equipment composition and backplane access points map
- EGSM - ILLUSTRATIVE 2 - Modules access points map and external access points map
- GSM-R - ILLUSTRATIVE 1 - Equipment composition and backplane access points map
- GSM-R - ILLUSTRATIVE 2 - Modules access points map and external access points map
- 4) INSTALLATION AND POWER-UP PROCEDURES
- ABBREVIATIONS AND ACRONYMS
- INDEX
SAFETY RULES Page 4 ENG
ANNEX 1
When the equipment or the modules are equipped with the labels as shown here below, it is essential to
observe the warnings contained
-LIVE VOLTAGE POINT
-PROTECTIVE EARTHING TERMINAL
BLACK
-CLASS 1 LASER PRODUCT
EXPLANATORY LABEL (affixed to the WARNING LABEL (affixed to the CLASS 1 product side)
CLASS 1 product front)
Products which are of CLASS 1 as defined in the IEC EN 60825-1, fourth edition “Safety of lase
r
products -Part 1: Equipment classification, requirements and user's guide”. Even if the product is o
f
CLASS 1, please observe the following safety procedures, prescribed in the cited norm:
• do not observe directly the laser beam,
• do not use observation optics (lens, microscopes, telescopes, etc.),
• do not expose eyes directly.
BLACK
YELLOW
BLACK
YELLOW
BLACK