User's Manual

800MHz-900MHz Off-Air Repeaters (OR Series) Page 91 080 0716F – Rel.06
CHAPTER 4
11
- Click ‘Ok’ to start the software.
The window ‘Communication settings’ is displayed: check that local ‘Connection mode’ is selected.
If remote Connection mode is selected it is possible to change the Connection mode as follows:
- select the ‘Edit and save’ button in the lower part of the panel to enable changes;
- select local Connection mode;
- press the ‘Edit and save’ button again to confirm (FIGURE 9).
FIGURE 9 – ‘COMMUNICATION SETTINGS’ PANEL
9. SET THE REPEATER GAIN, FREQUENCY CENTER AND BANDWIDTH
- Select the menu entry ‘Read’ in the ‘Communications’ menu, or click the ‘
Read’ button, to read
the equipment configuration and status.
The software main window is displayed.
By means of the software set the repeater gain as described below.
NOTE
How to modify parameters:
- Click on the ‘edit and save’ button, in the lower part of the window, to enable changes to the repeater
parameters.
- Click again on the ‘edit and save’ button to save changes.
- The menu entry ‘Write’, in the ‘Communications’ menu, makes it possible to apply changes to the
repeater. A password is required: default password is blank. To change the password please refer to
the software User’s manual.
Edit and save
button