User's Manual

800MHz-900MHz Off-Air Repeaters (OR Series) Page 91 080 0716F – Rel.06
CHAPTER 4
10
8. START OMT Repeater IN LOCAL MODE
In LOCAL mode the notebook is connected to the repeater via RS232 serial cable.
- Open the repeater door (by unscrewing four screws located on the equipment front door).
Connect your notebook to the management module (connector RS232, ref. 34, FIGURE 7) using the
provided serial cable (null-modem type).
FIGURE 7 – RS232 CONNECTORS
- The connector RS232 (ref. 58,FIGURE 7) and the connector RS232 (ref. 59, FIGURE 7) are
connected with a cable (only in models equipped with CDMA modem).
- Switch on your notebook and start Windows
- To Run the program select the related folder in the Windows ‘Start’ menu and click.
- The ‘Login panel’ is displayed (FIGURE 8).
FIGURE 8 – LOGIN PANEL
.
- Select read/write user.
PLEASE NOTE It’s not requested to insert the password the first opening of the program. It’s
recommended to change the password to avoid undesired accesses to the program (to change the
password, please refer to the Operation and Maintenance Terminal Software User’s manual).
RS232
Repeater
ref. 34
P
HIGH POWER AMPLIFIE R
IN
SPV BUS
OUT
UP LINK
132KHz
ALARM
+5V
RL
OPERATING
U
ULNA
HPA D
D
BS 1
BS 2
HIGH POWER AMPLIFIE R
SPV BUS
DOWN LINK
P
IN
OUT
In
Out
Out
In
BAND-SELECTIVE 1
In
Out
In
Out
DOWN-LINK
UP-LINK
DOWN-LINK
UP-LINK
BAND-SELECTIVE 2
POWER SUPPLY
5V5 10V5
LNA DOWN
LNA UP
RS232 (Repeater) RS232 (Modem)
RS232
Link
ref. 59
RS232
Modem
ref. 58