Handbook
Table Of Contents
- 1 Introduction
- 2 ClearFill®Star System Description
- 3 System Design Guidelines
- 3.1 CDMA Basics (in preparation)
- 3.2 Required information for system design
- 3.3 Design step by step
- 3.4 Estimated RF Coverage per RRH
- 3.5 Right-sizing - the beacon feature (in preparation)
- 3.6 Capacity demand - number for BSIs (in preparation)
- 3.7 System Architecture
- 4 System Installation
- 4.1 General
- 4.2 System Installation (Hardware Installation)
- 4.3 Installation Radio Remote Head (RRH)
- 4.4 Installation Gigabit Ethernet Switch (GES)
- 4.5 Installation Base Station Interface (BSI)
- 4.6 Installation NMS Server (Hardware)
- 4.7 Commissioning of NMS
- 5 NMS Overview
- 5.1 Introduction
- 5.2 Starting the NMS
- 5.3 Tools and Utilities of NMS server
- 5.4 Main Window of NMS Application Client (structure)
- 5.5 The NMS client functionality
- 5.6 Right Click Menus
- 5.7 RRH Configuration
- 5.8 BSI Configuration
- 6 Configuration Management
- 7 System Supervision
- 8 Remote Management and Supervision
- 9 Operational used cases/Maintenance
- 10 System Specifications and Technical Data
- 11 Conformance Statements
- 11.1 United States
- 11.1.1 Introduction
- 11.1.2 Federal Communications Commission (FCC)
- 11.1.3 FCC Part 15 Class A
- 11.1.4 RF approval
- 11.1.5 IEC product safety conformance
- 11.1.6 Indoor applications
- 11.1.7 Antenna exposure
- 11.1.8 Radiofrequency radiation exposure Information
- 11.1.9 Packaging collection and recovery requirements
- 11.1.10 Recycling / take-back / disposal of products and batteries
- 11.2 Canada
- 11.1 United States
- 12 Appendix
ClearFill Star CDMA
1100187 Rev. 1.0
Page 61 of 152
4.7.3.3 STP configuration of GES
The ClearFill®Star system uses the spanning tree protocol. It has to be activated in every
GES. Procedure to set a GES to support STP:
1. Open Microsoft Internet Explorer.
2. Enter the address “http://192.168.1.1” in the address window.
3. Login to the switch by using
Username: admin
Password: admin
4. Click on STP in the left-hand sides menu.
5. Click on the appearing sub menu Configuration, see Figure 29 for the STP menu that
appears.
6.
Set “Spanning Tree Protocol” to: enable (via drop down menu).
7. Set Bridge Priority to:
a. 36864 for an access switch (switch that is not directly connected to a BSI)
b. 4096 for a root switch
8. Set Hello Time to: 1
9. Set Max.Age to: 6
10. Set Forward Delay to: 4
11. Set Force Version to: RSTP (via drop down menu)
12. Click on Apply.
13. Click on Reboot on the left hand side menu.
14. Click on “Save and Reboot” in the left hand side menu.
Repeat this procedure with every GES in the network. Start with the switch that is closest to
the BSIs (root switch) and follow the network topology to the GES that has the longest
topological distance to the BSI (access switches).
After following this procedure all GES are ready for STP usage.
Figure 29 GES STP configuration menu