Handbook

ClearFill Star CDMA
1100187 Rev. 1.0
Page 148 of 152
11.1.6 Indoor applications
This equipment is intended for installation in restricted access locations where access is
controlled or where access can only be gained by service personnel with a key or tool.
Access to this equipment is restricted to qualified service personnel only.
11.1.7 Antenna exposure
Antenna installations for the Clear Fill Star product shall be performed in accordance with all
applicable manufacturer's recommendations, and national laws and regulations. To ensure
correct antenna installation, the antenna installer shall perform all necessary calculations
and/or field measurements to evaluate compliance with applicable national laws or
regulations regarding exposure to electromagnetic fields. The supplier of radio equipment,
the supplier of antenna equipment and the integrator and builder of the site must provide
sufficient information so that the limits of the exclusion zones can be determined. Any
changes to the antenna or other equipment in the transmit path may require re-evaluation of
the exposures to electromagnetic fields.
Pursuant to 47 CFR Part 1, Subpart I, subject to the provisions of section 1.1307, all
installations must be evaluated for requirements contained in Table 1, “Limits for maximum
permissible exposure,” in section 1.1310.
11.1.8 Radiofrequency radiation exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 20
cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
11.1.9 Packaging collection and recovery requirements
Countries, states, localities, or other jurisdictions may require that systems be established for
the return and/or collection of packaging waste from the consumer, or other end user, or from
the waste stream. Additionally, reuse, recovery, and/or recycling targets for the return and/or
collection of the packaging waste may be established.
For more information regarding collection and recovery of packaging and packaging waste
within specific jurisdictions, please contact the RFS customer services.
11.1.10 Recycling / take-back / disposal of products and batteries
Electronic products and batteries bearing or referencing the symbols shown below shall be
collected and treated at the end of their useful life, in compliance with applicable European
Union and other local legislation. They shall not be disposed of as part of unsorted municipal
waste. Due to materials that may be contained in the product and batteries, such as heavy
metals, the environment and human health may be negatively impacted as a result of
inappropriate disposal.