Handbook

ClearFill Star CDMA
1100187 Rev. 1.0
Page 130 of 152
9 Operational used cases/Maintenance
9.1 Introduction
This chapter provides instructions for the most common use cases. It also provides
instructions on how to contact RFS in case of hardware defects.
9.2 Swap faulty devices
Please contact RFS in case of broken hardware. The procedure for contacting RFS is
described in section RFS Maintenance Services. The following swap procedures assume
that a new or repaired device is already available to be swapped.
9.2.1 Swap RRH
Swapping procedure for an RRH:
1. Disconnect old RRH from GES.
2. Remove old RRH from wall mounting.
3. Write down MAC address of new RRH and update it in your local setup
documentation.
4. Attach new RRH to wall.
5. Connect RRH to GES at same port that the old RRH was connected to.
6. Start ClearFill Star Application Client.
7. Run template AddClearFillObj (see section 5.5.3.1.1) to add the RRH to the network
database.
8.
Delete sector of old RRH with template RemoveSector (see section 5.5.3.1.4).
9.
Reconfigure sector by running template SectorConfiguration (see section 5.5.3.1.5).
10.
Fine tune RRH by using the RRH configuration menu (see section 6.2.2).
9.2.2 Swap GES
Before the GES is swapped write down all the parameters of the old GES (as long as they
are still accessible).
Swapping procedure:
1. Disconnect all cables from the old GES.
2. Connect all cables to the same ports as before at the new GES.
3. As soon as the GES is powered enter the switch menu (see section 4.2) and change
the default IP address (192.168.1.1.) to the address that was previously used by the
old GES. (Change to the IP menu on the left hand side, Change the IP address and
click to apply).
4.
Configure VLAN, STP and SNMP settings as described in section 4.2..
5.
Click to Reboot menu on the left hand side and click to “Save and Reboot”.