Handbook
Table Of Contents
- 1 Introduction
- 2 ClearFill®Star System Description
- 3 System Design Guidelines
- 3.1 CDMA Basics (in preparation)
- 3.2 Required information for system design
- 3.3 Design step by step
- 3.4 Estimated RF Coverage per RRH
- 3.5 Right-sizing - the beacon feature (in preparation)
- 3.6 Capacity demand - number for BSIs (in preparation)
- 3.7 System Architecture
- 4 System Installation
- 4.1 General
- 4.2 System Installation (Hardware Installation)
- 4.3 Installation Radio Remote Head (RRH)
- 4.4 Installation Gigabit Ethernet Switch (GES)
- 4.5 Installation Base Station Interface (BSI)
- 4.6 Installation NMS Server (Hardware)
- 4.7 Commissioning of NMS
- 5 NMS Overview
- 5.1 Introduction
- 5.2 Starting the NMS
- 5.3 Tools and Utilities of NMS server
- 5.4 Main Window of NMS Application Client (structure)
- 5.5 The NMS client functionality
- 5.6 Right Click Menus
- 5.7 RRH Configuration
- 5.8 BSI Configuration
- 6 Configuration Management
- 7 System Supervision
- 8 Remote Management and Supervision
- 9 Operational used cases/Maintenance
- 10 System Specifications and Technical Data
- 11 Conformance Statements
- 11.1 United States
- 11.1.1 Introduction
- 11.1.2 Federal Communications Commission (FCC)
- 11.1.3 FCC Part 15 Class A
- 11.1.4 RF approval
- 11.1.5 IEC product safety conformance
- 11.1.6 Indoor applications
- 11.1.7 Antenna exposure
- 11.1.8 Radiofrequency radiation exposure Information
- 11.1.9 Packaging collection and recovery requirements
- 11.1.10 Recycling / take-back / disposal of products and batteries
- 11.2 Canada
- 11.1 United States
- 12 Appendix
ClearFill Star CDMA
1100187 Rev. 1.0
Page 127 of 152
Status
LED Description of Function
OK Failure
1
Green State LED
A blinking state indicates that the processor
is operational. This LED also flashes in
response to the NMS flash attention LEDs
command (used to identify a particular node
in the network). A static state (ON or OFF)
indicates that the processor is no longer
operating correctly, a power-cycle is
required to recover from this state.
Blinking /
Flash
Off /
On (Static)
2
Amber Warning LED.
This LED flashes in response to the NMS
flash attention LEDs command (used to
identify a particular node in the network).
Flash N/A
3
Red Error LED.
Indicates a processor boot failure. When the
node is powered-up this LED blinks and
then remains off. If the processor fails to
successfully execute it’s internal boot
sequence on power-up the LED remains on.
Off
On /
Blinking
4
Green Link Status LED.
When the node has successfully negotiated
1000BASE-T full duplex mode this LED is
on. LED off state indicates that the
negotiating failed, or the link is down. The
node only supports 1000BASE-T operation.
On Off
5
Orange Link Transmit LED.
This LED illuminates when the node is
transmitting Ethernet data.
Blinking /
On / Off
N/A
Table 11 LED indication at BSI