User's Manual

Part Number: J24004

Drawing Control: JD16049

discontinue service. When practical, they will notify you in advance of this disconnection. If advance notice is not

feasible, you will be notified as soon as possible. When you are notified, you will be given the opportunity to correct

the problem and be informed of your right to file a complaint with the FCC. Contact your telephone company if you

have any questions about your phone line. In the event repairs are ever needed on the intelliBDA, Celwave or an

authorized representative of Celwave should perform them. For information contact:

Celwave-Corvallis

4100 SW Research Way

Corvallis Oregon 97333-1066

RF CONNECTIONS

The primary RF connections are made via two type "N" female connectors. The connector labeled "BASE

STATION" must be connected to the antenna/system pointing towards the base station. The connector labeled

"SERVICE AREA" must be connected to the antenna/system pointing into the service area.

AC / DC POWER

The 48660 comes with a standard 6 ft. US type NEMA 5-15P 3-wire male plug with phase, neutral, and safety

ground wires. AC power is only used to supply a high-efficiency 24 VDC switching power supply. This supply has

been thoroughly tested by Celwave for temperature capability, modulation effects, and harmonic coupling into the

RF circuitry. All internal components are powered by 24 VDC.

{Power supply listings: UL E100527 Vol. 6 (USA), CSA LR64950-40 (Canada), TUV R9472032 (Europe), VDE

NR84964 (Germany).} ****CHECK NEW LISTINGS!!!********

The 48660 Intelli BDA is fused to prevent further damage should the BDA fail. The fuse located in the AC

receptacle housing. To replace, unplug power cord and with finger, apply slight downward pressure on the fuse door

while pulling out. The door will open and the fuse can then be replaced with a 3.15 Amp 5 x 20 mm type fuse or

equivalent. Never replace with a higher amperage rated fuse! This may cause damage to the 48660 Intelli BDA and

void warranty.

WARNING: 120 VAC can be lethal. Never insert conductive objects into any opening.

The 48660 Intelli BDA has a 3 pin DC connector on the front panel. This can be used to supply DC power between

+20 V and +28 V for battery back up applications. If AC power is present, the 48660 will not draw any current from

this connector. Once AC power is removed, the Intelli BDA senses if there is a voltage present at this port and

begins to draw current. If the voltage at this port ever drops below +20 Volts DC, the 48660 will turn itself off until

AC power is restored.

The DC input is protected against short circuit, over voltage and reverse polarity conditions. It cannot be used to

charge batteries. This DC input is fused with the same fuse as used in the AC Power receptacle housing. To access

the DC fuse, first remove AC and DC power from the Intelli BDA, open shroud and with a fuse puller or equivalent

tool, remove fuse located in bottom right corner of the Digital Board (See Figure X.X). Replace with a 3.15 Amp 5

x 20mm fuse or equivalent. Never replace with a higher amperage rated fuse!!! This may cause damage to the 48660

Intelli BDA and void warranty.