User manual

Digital BUS-WATCH
®
HDx00
Page 24 of 93
Radio Engineering Industries, Inc.
640430 -- Rev A -- 9/7/2012
Connect Camera Switching Devices (P/N 700462 or 710030) as needed for
multiple camera systems.
If the System operates in the Manual Record Mode, connect the red wire (labeled
12V SW), to the switched side of the ignition switch. The red wire should be fused at 1
A. The red wire does not need to be connected if the system is in Timer Record Mode,
however, best practices should include this connection in case DVR configuration is
changed in the future.
POWER
VIEW
REAR
IGN
VIA IGN SWITCH
TO BATTERY
TO BATTERY
(UNSWITCHED)
WHT
BLK
RED
512002 - 16 FT.
HD DVR POWER CABLE
SWITCH MAY BE VEHICLE IGNITION
OR USER INSTALLED TOGGLE SWITCH
CAM
1
BUS-WATCH DVR, HD800
710331
HR-SERIES
EXTERIOR
DOME
WEDGE
INTERIOR
WEDGE
CAM
2
CAM
3
CAM
4
*Connect WHITE wire DIRECTLY to the positive
terminal of the battery.
*Connect BLACK wire DIRECTLY to the negative
terminal of the battery.
System Wiring
Note: White wire fused @ 7A (1-6 Cameras), 10A for more cameras; Red wire fused @ 1A.
CAMERAS
POWER INPUTS
1 3
2
NETJ1939 ACC GPS USB
ANT1
ANT2
5 6
PANIC
4 87
AUX
512001 - 35 FT.
Figure 11: System Wiring – Power and Camera Cables