User manual
Digital BUS-WATCH®
32
Radio Engineering Industries, Inc.
640333
Rev 0 -- 1/1/2006
Set Vehicle ID Screen
This screen is used to set the Vehicle ID that will be shown on the on-screen display
during normal operation. The Vehicle ID can be up to sixteen characters long.
Reference: Figure 25.
Set Vehicle Identification Page Screen Shot
Figure 25
Use the UP and DOWN arrow buttons to change the flashing character to the desired
setting. Each character is changed individually. Press RIGHT or SEL to move to the
next character.
Calibration Screen
This submenu screen has three different options, Speedometer Calibration, and
Speedometer Signal Levels, and Screen Adjustment.
Note: These speedometer functions are used when connecting the speedometer input
to the transmission output pulses. The On Screen Display of the vehicle speed
automatically reverts to the GPS output when valid GPS data is present. When valid
GPS data is not present, as in long tunnels or around many very tall buildings, the
transmission pulse data will display if connected and calibrated properly.