User manual

Digital BUS-WATCH®
27
Radio Engineering Industries, Inc.
640333
Rev 0 -- 1/1/2006
DISPLAY OPTIONS
Allows the user to determine what information is recorded onto the screen.
PLAYBACK SEARCH OPTIONS
This screen directs users to specific portions of the video for fast retrieval.
RECORDING OPTIONS
Allows the user to change frame rates and compression levels.
Factory Default
If this item is selected, the system's internal settings will be set to the factory
defaults. This includes:
• Total Record Time reset to zero.
• Minimum and maximum temperature and voltage data erased and reset to
current conditions.
• Record Mode set to Manual
• Daylight Saving Time enabled.
• 24-hour Mode disabled.
• Off Delay set to 0 minutes.
• Screen width and position settings reset to defaults.
• Speedometer calibration reset to default (01AC).
• Vehicle ID reset to "REI004" (Figure 25 on Page 32).
• All Timers set to defaults as shown in Figure 51 on Page 52.
• Vehicle Sensor Options set to Transit Settings (Figure 40 on Page 43).
• Alarm Recording Options all turned Off as shown in Figure 48 on Page 48.
• On Screen Display Options set as shown in Figure 36 on Page 40.
• Playback Volume set to maximum output level (10).
Warning: Do not select this function unless you want ALL settings changed back
to their factory defaults!
System Information Screen
This screen is used to show information that might be useful during troubleshooting.
• SOFTWARE VERSION: The current version of control software.
• SERIAL NUMBER: The hardware serial number associated with the DVR.
• SPEEDO FACTOR: A number used by the microprocessor control software to
calibrate the internal speedometer that uses the transmission pulse outputs.
• RECORD HOURS: Total number of hours the Digital BUS-WATCH® IV unit has
recorded video footage.
• SYSTEM VOLTAGES: Minimum and maximum readings of the bus system
voltage.
• ENCLOSURE TEMPERATURES: Minimum and maximum readings of the
temperature within the Digital BUS-WATCH® IV cabinet.
Reference: Figure 18.