User manual
Digital BUS-WATCH®
17
Radio Engineering Industries, Inc.
640333
Rev 0 -- 1/1/2006
Physical Mounting Requirements
There are two common ways to mount the Digital BUS-WATCH® IV. First is the
under-seat, or hanging, method. This method mounts the slide bracket to the
underside of a seat. Second is the floor-mount method. This method mounts the
Digital BUS-WATCH® IV to the floor of the bus. Figure 9 shows the minimum area
for the system installation.
DVR Physical Mounting
Figure 9
Digital BUS-WATCH® IV Hanging Mount
(See Figure 10)
1. Find a suitable location under the first seat behind the driver or under
the driver’s seat.
2. An area 15-1/2 inches should be unobstructed in front of the slide
bracket to allow sliding the security cabinet onto the slide bracket.
3. If necessary modify the positions of the tower, connector box, and slide
rails according to the instructions above.
4. Position the slide bracket on the frame of the seat in the desired
location. Drill 5/16th inch holes through the frame using the bracket as
a guide.
5. Attach slide bracket to seat frame using nuts and bolts.