User manual

Digital BUS-WATCH®
9
Radio Engineering Industries, Inc.
640289
Rev B -- 11/18/2002
3. Insert the BW Options Harness by snapping it into place.
4. Route the excess harness through the provided hole
5. Assemble the connector box back onto the tower. Observe proper alignment
of connector when inserting into box.
Figure 4
Speedometer Harness
The BUS-WATCH® speedometer input wires are designed to be spliced directly onto
the transmission speedometer transducer wires. In some installations, this may not be
possible (i.e. mechanical speedometer, transmission manufacturer warnings, etc.). The
BUS-WATCH® Vehicle Speed Sensor Kit (P/N 750086) may be required.
Refer to the vehicle service manual for speedometer type, exact wire
location, and transmission manufacturer warnin
g
s.