User manual

Digital BUS-WATCH®
8
Radio Engineering Industries, Inc.
640289
Rev B -- 11/18/2002
(Optional) BW Options Harness
FLASHER
FROM
FLASHER
FROM
FROM
FLASHER
FLASHER
FROM
FROM
FLASHER
PEDAL SWITCH
FROM BRAKE
Figure 3
The BUS-WATCH® Options Harness (shown in Fig. 3) connects to various locations
in the vehicle to provide on-screen information regarding vehicle performance.
The monitored points in the vehicle are:
• Vehicle speed
• Brake activation
• Amber warning lamp operation
• Red warning lamp operation
• Stop arm lamp operation
• Optional points with AUX 1 & AUX 2 (Aux 1 & Aux 2 are user-defined and
may be used to monitor points such as turn signals, rear and front doors, etc.)
When using this option, the Digital BUS-WATCH® “learns” the off state of each
monitored point. To properly set polarity, all monitored points must be in the off
position upon when the Digital BUS-WATCH® is switched on.
(Optional) BW Options Harness Mounting Instructions
Install the BUS-WATCH® Option Harness (see Fig. 4) into the security cabinet.
1. Remove the four mounting screws connecting the tower to the slide bracket.
2. Remove the four screws holding the connector box to the tower.
(Optional)
BW Options Harness