User manual

Digital BUS-WATCH®
27
Radio Engineering Industries, Inc.
640289
Rev B -- 11/18/2002
Set Route ID Screen
This screen is used to set the Route ID that will be shown on the on-screen display
during normal operation. The Route ID can be up to sixteen characters long.
Figure 21
Use the UP and DOWN arrow buttons to change the flashing character to the desired
setting. Each character is changed individually. Press RIGHT or SEL to move to the
next character.
System Info Screen
This screen is used to show various information that might be useful during
troubleshooting.
• SPEEDO FACTOR: A number used by the microprocessor control software to
calibrate the internal speedometer.
• RECORD TIME: Total number of hours the Digital BUS-WATCH® unit has
recorded video footage.
• SYSTEM VOLTAGE: Minimum and maximum readings of the bus system
voltage.
• ENCLOSURE TEMPERATURE: Minimum and maximum readings of the
temperature within the Digital BUS-WATCH® cabinet.