User manual

Digital BUS-WATCH®
23
Radio Engineering Industries, Inc.
640289
Rev B -- 11/18/2002
• Speedometer calibration reset to default.
• Voltage calibration reset to default.
• Route ID reset to "REI001".
• All Timers set to defaults.
Warning: Do not select this function unless you want all settings changed back to
their factory defaults!
Record Mode
When set to 'T,' or TIMED, the command to start or stop recording comes from
the programmable timers. When set to 'M,' or MANUAL, the command to start or
stop recording comes from the System Switch.
Off Delay
Can be set to any number from 0 to 35. This is the number of minutes the Digital
BUS-WATCH® will continue to record after the System Switch has been turned
off. The default for this setting is 16 minutes. Note: This function only works in
MANUAL Record Mode (see below). Off delay is not used if the unit is configured
to use the programmable timers.
Daylight Savings Time
When set to Yes, the system clock will change automatically with Daylight Savings
Time. If your region does not use Daylight Savings Time, this function may be
disabled by setting this item to No.
24-Hour Mode
When set to Yes, the clock will be displayed in a 24-hr format. If set to No, the
clock will be displayed in a 12-hr. format.
Display Options
This item takes you to another screen that allows you to customize what is shown
on this unit's on-screen display. An asterisk beside the item indicates that the item
in question will be shown on-screen during normal operation. Pressing the SEL
button when the cursor is set to a particular line toggles the asterisk on or off.