User manual

Digital BUS-WATCH®

Radio Engineering Industries, Inc.

640289

Rev B -- 11/18/2002

When the image is downloaded, it is displayed on the PC screen and can be

saved as a PC file.

• If you want to download more images, you can either use the control panel on the

Digital BUS-WATCH or right-click on the Viewer window and click REMOTE to re-

open the virtual control panel. Before you can move to the next image, however,

you must either press STOP on the virtual control pad or SEL on the front panel.

When you do this, the BACKUP indicator on the video screen should disappear.

You can then move the video image to the next image you want to download.

Repeat the two previous steps.

• When your are finished downloading images, press the EXIT button on the front

panel of the Digital BUS-WATCH. This switches the unit back into the MENU

mode, and transfers control from the PC back to unit's control panel.

• Press EXIT to return to the previous menu.

Set Options Screen

Figure 17

Select which item to change by using the arrow buttons, then press SEL to change the

item.

Factory Default

If this item is selected, the system's internal settings will be set to the factory

defaults. This includes:

• Total Record Time reset to zero.

• Minimum and maximum temperature and voltage data erased and reset to current conditions.

• Record Mode set to Manual

• Daylight Savings Time enabled.

• 24-hour Mode disabled.

• Off Delay set to 16 minutes.

• Screen width and position settings reset to defaults.