User manual

Digital BUS-WATCH®

Radio Engineering Industries, Inc.

640289

Rev B -- 11/18/2002

Digital BUS-WATCH® Floor mount

Find a suitable location to mount the slide bracket on the floor. The Digital BUS-

WATCH should not present a trip hazard or head impact hazard and should not

interfere with the seating, safety, or comfort of the passengers.

1. An area 15 and 1/2 inches should be unobstructed in front of the slide bracket

to allow sliding the Digital BUS-WATCH® onto the bracket.

2. Position the slide bracket on the floor and drill four 3/16th inch holes into the

floor using the mounting holes as a guide.

3. Set aside the slide bracket. Position four rubber shock mounts over the pilot

holes.

4. Place the slide bracket over the rubber shock mounts. Align the mounting

holes to the center of the shock mounts.

5. Secure slide bracket to the floor using four lag bolts.

6. Carefully slide the cabinet onto the slide bracket being sure to check alignment

of the connector. Lock to secure.

Figure 9