User's Manual

DMR repeater 24/01/2011 Versione 1.1
Documento Riservato - non divulgabile senza autorizzazione
Pag. 49 / 55
It is necessary to insert the ID (or the group ID) of the terminals designed to receive the warning messages.
If the message has to be sent to a group of terminals, select Group ID
It is possible to set how many times sending the alarm message consecutively by selecting Repetitions ,
and how frequently (seconds) by selecting Interval
It is possible to set the timeslot the warning messages will be sent by selecting TS 1 or TS 2 .
Select Write to activate the current settings.
Alarm Event
I/O 1 Active I/O 1 contact
I/O 2 Active I/O 2 contact
Supply undervoltage Voltage supply under the minimum value
Supply overvoltage Voltage supply over the maximum value
Ethernet link Link Ethernet disrupted
MST/SAT sync Loss of synchronism between Master and Satellite
Environmental
temperature
Environmental temperature out of range
TX Temperature TX temperature out of range
RX lock RX unlocked
Connection to master Connection with working Master (Satellite only)
Satellite registration Registration of new Satellite (Master only)
Satellite deregistration Deregistration of new Satellite(Master only)
Satellite lost Unreachable satellite(Master only)
GSM/GPRS not working
GSM/GPRS connection not working (only for Base Stations equipped with I/O board
and GSM/GPRS module)
Noise on the RF
channel
Not yet active