User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 72 of 95
A Scene consists of all Belt Pack settings except Id, Display, and Passcode settings. Each Belt Pack can
store up to 10 different scenes.
Uses the Scenes menu to Add, Remove, and Rename Scenes.
RECEIVER ONE AND RECEIVER TWO
Frequency
Belt Pack receivers and Base Station transmitters use the UHF band from 470 to 608MHz, 614 to
616MHz and 653-663MHz. Enter a frequency from 470.025MHz to 607.975MHz, or from 614.025MHz
to 615.975MHz and 653.025MHz to 662.975MHz. Below 655.000MHz frequencies must be evenly
divisible by 10 or 25 kHz. Above 655.000MHz frequencies must be evenly divisible by 25 kHz. Allow at
least 25 kHz bandwidth between receivers.
Right-click on a Frequency field to pop up a Frequency menu.
Enable
A receiver may be disabled if it is not needed, but only one of the Belt Pack's two receivers can be
disabled.
Lock
While the Belt Pack is connected via USB, the lock status is continually updated.
RSSI
While the Belt Pack is connected via USB, the RSSI is continually updated.
RECEIVER
The Attenuation field applies to both receivers.
Attenuation
Options include 0dB (no attenuation), 5dB, 10dB, 15dB, and 20dB.
Using Shortcut Keys
CTRL-D (COPY DOWN)
If the user changes one setting and then holds down the Ctrl key while pressing D (Ctrl-D), the setting
will be copied down to all the fields below it. This makes it easy to give all receivers to the same
settings.