User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 67 of 95
The routing settings allow the user to route each of the Belt Pack's four transmit buttons separately.
Routing options include Mute, Channel 1, Channel 2, Channel 1 and 2, WTA 1, WTA 2, WTA 1 and 2, SA,
SA plus WTA 1, SA plus WTA 2, SA plus WTA 1 and 2, Aux Out, Aux plus WTA 1, Aux plus WTA 2, and
Aux plus WTA 1 and 2.
TRANSMITTERS
The transmitter settings allow the user to change the transmitter frequencies and power levels, as well
as enabling or disabling them.
Frequency
Base Station transmitters and Belt Pack receivers use the UHF band from 470 to 608 MHz, 614 to 616
MHz & 653 to 663 MHz. Enter a frequency from 470.025 to 607.975 MHz, or from 614.025 to 615.975
& 653.025 to 662.975 MHz. Below 655 MHz frequencies must be evenly divisible by 10 or 25 kHz.
Above 655 MHz frequencies must be evenly divisible by 25 kHz. Allow at least 25 kHz bandwidth
between receivers.
Right-click on a Frequency field to pop up a Frequency menu.
Power
Frequency Dependent 20mW, 50mW, 100mW, or 250mW based on post FCC 600MHz auction
guidelines.
Enabled
A transmitter may be disabled if it is not needed.
Lock Status
While the Base Station is connected the Lock Status is continually updated.