User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 57 of 95
Button Labels
...........0.dB
BACK
Button.Labels
Rx.Atten:
SAVE BACK
• To change the setting for R
x Atten, press SELECT.
• Use either encoder to change the parameter.
• When done, press SAVE to save the changes or BACK to ignore them.
Master Volume
The Master Volume menu option in the Advanced Settings sub-menu allows the user to set a ratio for
the audio levels of both receiver channels that will be heard in the headset. By default, the ratio is 1:1
(CH1 = CH2). This parameter can be adjusted in 2dB increments, up to a maximum of 12dB.
When the Status is set to Disabled, the volume controls will be independent for each channel.
.........CH1.=.CH2
Status:..Disabled
BACK
Ratio :
Status:..Disabled
SAVE BACK
Ratio :..CH1.=.CH2
.........Disabled
BACK
Ratio :..CH1.=.CH2
Status:
SAVE BACK
• To change the setting for Ratio or Status, press SELECT
• Use either encoder to change the parameter.
• When done, press SAVE to save the changes or BACK to ignore them.
Headset Options
There are two local headset options: Combined or Separate.
This setting controls where the receiver audio gets routed, to the left and/or right earphone.
If Separate is selected, audio for Receiver 1 will be routed to the left earphone and audio for Receiver 2
will be routed to the right earphone.
If Combined is chosen, audio for both receivers will be routed to both earphones.
Note: if only one receiver is enabled then audio to that receiver will be routed to both earphones no
matter what headset option is chosen.