User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 54 of 95
....496.000
R2: 649.000
BACK
This screen lists the frequency (in MHz) of both receivers as well as the status.
For example, if receiver one is disabled, R1: Disabled will be displayed.
If a frequency is listed instead of Disabled, then it is enabled and receiving at the specified frequency.
• To change frequency or status, scroll to the receive
r you desire to change.
• Press SELECT and the screen will change to the following:
R1.Freq..:.496.000
...Status:.Enabled
BACK
• To change the frequency, press SELECT and the first frequency digit will be boxed (see
below).
• Use the encoder to change the boxed digit and press SELECT to change which digit is boxed.
• Once the frequency has been changed as desired, press SAVE to save the change or BACK to
ignore it.
The Belt Pack receiver frequency range is 470-608MHz and 614-616MHz and 653-663MHz (UHF).
R1.Freq..:.496.000
...Status:.Enabled
SAVE BACK
The status enables (turns on) / disabled (turns off) the receiver.
Turn off an un-needed receiver to save battery power.
• To change the status, scroll down to box Status and press SELECT.
• Turn the encoder to change the selection
• Press SAVE to save the change.