User's Manual
UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 45 of 95
TRANSMIT STATUS INDICATORS
The Belt Pack home screen will display the status of the transmitter. When the transmitter is active, a
boxed ‘T’ will appear on the screen next to the label for that button.
Below are some examples.
SIG: BATT: OK
DIRECTOR T CAMERA 1
WTA 1
WTA 2
SIG: BATT: OK
DIRECTOR CAMERA 1
WTA 1
WTA 2
SIGNAL AND BATTERY INDICATORS
The signal meter displays an average of the signal strength of both receivers (Rx1 and Rx2) if both are
enabled. If only a single receiver is enabled, the signal meter will display the signal strength of that
receiver only.
SIG: BATT: OK
DIRECTOR CAMERA 1
WTA 1
WTA 2
The battery indicator will simply show “BATT: OK” when the battery level is greater than approximately
15%, and “BATT: LOW” when the battery level is below approximately 15%. The low battery threshold
depends on the battery type and is automatically detected by the Belt Pack.
HEADSET VOLUME
The headset volume is changeable via the two rotary encoders (see Figure 5):
• Left adjusts volume on Channel One
• Right adjusts volume on Channel Two
If master volume is enabled, both encoders change the volume of both channels. The ratio between
the channels is configurable. See the Master Volume section.
POWER / MENU BUTTON
This button is used to turn on and off the Belt Pack, as well as to get into and out of the menu.
• When the Belt Pack is off, press the button to turn it on.
• When on, press and hold (approximately 3 seconds) to turn it off.
• To get into or out of the menu, when the Belt Pack is on, press (without holding) the button.