User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 34 of 95
TRANSMITTER SETTINGS
The transmitter settings allow the user to change the transmitter frequencies and power levels as well
as enabling/disabling them.
• From the home screen, press MENU, scroll to TX SETTINGS, press SELECT.
The screen will appear as follows:
............100mW...496.000
........T2: 100mW...649.000
........
BACK....
This screen lists the frequency (in MHz) of transmitters, power level, and status (enabled/disabled).
If a transmitter is not installed, it will display NOT INSTALLED.
For example, if Transmitter One is disabled, T1: DISABLED will be displayed. If it is enabled, then it will
be displayed as it is shown above.
• To change any of these settings, scroll to the transmitter you desire to change, press SELECT
and the screen will appear as follows:
........T1...........100mW
.............Freq : 496.000
.............Status: Enabled
BACK....
• To change the transmitter power, press SELECT.
• Use the encoder to change the value.
• Press SAVE to save or BACK to cancel the change.
SAVE....T1...Power :
.............Freq : 496.000
.............Status: Enabled
BACK....
• To change the frequency, select FREQ and the first frequency digit will be boxed (see
below).
• Use the encoder to change the boxed digit and press SELECT to change which digit is boxed.
• Press SAVE to save the change or BACK to cancel.
........T1...Power : 100mW
.....................496.000
.............Status: Enabled
B
ACK....
SAVE.....T1...Power : 100mW
..............Freq : 96.000
..............Status: Enabled
B
ACK....