User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 30 of 95
If a receiver is not installed, it will display NOT INSTALLED.
• Use the rotary encoder to navigate to the desired receiver and press SELECT to change the
receiver frequency or status (enabled / disabled).
The following is an example of selecting R1:
........R1 Freq : 175.000
........ Status: Enabled
........
BACK....
• To change the frequency, press SELECT; the first frequency digit will be boxed (see below).
• Use the encoder to change the value of the boxed digit (up / down).
• Press SELECT to move on to the next digit.
• Once the frequency has been changed as desired, press SAVE to save the change or BACK to
cancel.
SAVE....R1 Freq : 175.000
........ Status: Enabled
........
BACK....
• To change the status, scroll down to S
TATUS and press SELECT.
• Use the encoder to change the selection and press SAVE to save the change.
........R1 Freq : 175.000
........ Status: Enabled
........
BACK....
SAVE....R1 Freq : 175.000
........ Status: Enabled
........
BACK....