User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 29 of 95
BASE STATION MENU STRUCTURE
PASSCODE PROTECTION
The Base Station menu can be protected by a passcode.
• From the home screen, press the MENU button to change the screen as shown below:
MENU....M.........R1 C1...R4 OFF
MENU....T1 50mW...R2 C2...R5 NTx
MENU....T2 50mW...R3 OFF..R6 W1
RSSI....HS: OFF
INFO......Enter the Passcode:
MENU....
MENU........0....*....*....*
BACK....
*
The passcode is four digits; each digit can be any 0 – 9 number.
• Use the rotary encoder (see #4 on Figure 1) to change the value.
• Press SELECT to change selected (boxed) digit.
• Once the last digit is entered, press SELECT.
If the entered passcode is correct, the menu screen will be displayed.
If it is incorrect, INVALID PASSCODE will display for three seconds before returning to the home
screen.
See ENABLING/DISABLING THE PASSCODE and CHANGING THE PASSCODE for instructions on how to
enable/disable and change the passcode.
RECEIVER SETTINGS
The receiver settings allow the user to change the receiver frequencies, as well as enable or disable
them.
• From home screen, press MENU, scroll to RX SETTINGS, press SELECT.
The screen will appear as follows:
............175.000
........R2: 200.000
BACK....R3: 202.000
This screen displays the frequency (in MHz) of all six receivers.
If a given receiver is disabled, the word DISABLED will appear in place of a numerical frequency value.