User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 23 of 95
QUICK START GUIDE
BASE STATION
1. POWER: Insert power supply plug into the power connector located on the back of the Base
Station.
2. ANTENNAS:
Connect the supplied Shure VHF antenna (Lavender stripes) to RX input.
Connect the Shure UHF antenna (Green stripes) to TX1 (TX1+2) output. Ensure switch is set
to combined mode.
3. CONNECT HEADSET: Insert the headset connector into the Base Station until it snaps into
place.
4. POWERING ON/OFF: Press and hold the power button to power on. The display will turn on,
as well as various LEDs. Press and hold the power button to power off.
5. TX & RX FREQUENCIES: Program the transmitter and receiver frequencies as desired.
See the UV-1G PC Application (supplied) for information on how to program frequencies
from the Base Station itself.
NOTE: Defaults for Rx 1 – Rx 6 are 177.700MHz, 184.700MHz, 187.770MHz, 185.690MHz,
201.425MHz, and 193.915MHz. The default for Tx1 is 497.975MHz and Tx2 is 570.025MHz.
6. INTERCOM 2W / 4W: Select Audiocom (Telex), Clear-Com, or RTS mode via the menu.
Enable the 2W or 4W intercom using the intercom 1 and 2 select buttons (see Front Panel
Button Descriptions).
After connecting the 2W intercom to an external 2W device, the given intercom channel
(CH1 or CH2) must tune itself in order to maximize nulling of undesirable audio artifacts.
Upon power-up, the Base Station will automatically perform the 2W tuning process: a low
level of white noise is sent on the given 2W channel line for a few seconds.
Upon tuning completion, the intercom is ready to use. If a wired intercom is connected while
the Base Station is powered on, the tuning process must be manually started by the user:
press the Intercom Select button (CH1 or CH2) until the intercom goes from disabled to
enabled, at which point the tuning process will begin.
NOTE: This tuning process is only for wired 2W intercoms. It does not affect the 4W
intercoms.