Parts List/Tune Up Info

.016
.380
.760
.560
A
.150
2X .070
2X .090
2X .035
.380
.036
D
SCALE 4:1
D
USE THIS HOLE
TO HANG FOR
PLATING
.200
DETAIL A
SCALE 2 : 1
FLAT
PATTERN
(SUGGESTION)
TABS ON
ENDS ONLY
TABS ON
ENDS ONLY
D
D
REVISIONS
REV. DESCRIPTION DATE APPROVED
A PRODUCTION RELEASE 2/18/2013
B
ENLARGED ISO VIEW; ADDED FLAT
PATTERN VIEW; CHANGED TAB
LENGTHS; ADDED NOTE 8
3/7/2013
C INCREASED LENGTH OF TABS 7/25/2013
D
ADDED HOLE TO HANG FOR PLATING;
ADDED TAB LOCATION NOTES
8/5/2013
THIRD ANGLE PROJ.
D
WIS GEN 1 ANTENNA BELT PACK RX
10-0317
SHEET:
1 OF 1
DATE
02/18/13
SHEET SIZE
A
APPROVALS
PROPRIETARY NOTE:
32
MAT
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN INCHES 1.
TOLERANCES: .XXX
.010 .XX .015 ANGLES 3° 2.
REMOVE BURRS AND SHARP EDGES .015 MAX. 3.
NORMALITY, SQUARENESS AND PARALLELISM OF 4.
MACHINED SURFACES .004
MACHINED DIAMETER ON A COMMON CENTERLINE 5.
CONCENTRIC WITHIN .002 T.I.R.
ALL MACHINED SURFACES 6.
.016" COPPER STRIP
This document and the information it contains
are proprietary and may not be used,
assigned, or copied without the written
consent of Radio Design Group
DRAWN BY
D. BULLOCK
SCALE:
FIN
SEE NOTE 7
APPROVED
8925 Rogue River Highway, Grants Pass, OR 97527-4377
RADIO DESIGN GROUP, INC.
1:1
DWG NO.
CHECKED
7.
FINISH: SILVER PLATE PER QQ-S-365D, Type II, Grade A ( DO NOT USE NICKEL IN THE PLATING PROCESS)
8. CORNERS MUST NOT BE ETCHED FOR BENDING - ADVERSELY AFFECTS RF PERFORMANCE