Parts List/Tune Up Info

.031
0
.17 .89
1.61
1.781
0
.17
.78
2.18
2.82
2.981
D
SEE NOTE 10
( BOTTOM EDGE ONLY )
.165
R.035
.072
R.076
.18
2X R .03
.09
1.426
.130
2X .070
1.426
ETCHED FOR
BREAK-AWAY
(SEE NOTE 9)
D
C
REVISIONS
REV. DESCRIPTION DATE APPROVED
A PRODUCTION RELEASE 2/18/2013
B
ADDED NOTE 8; REDUCED
LENGTH OF TABS
3/7/2013
C
CHANGED HEIGHT AND
MATERIAL THICKNESS
3/7/2013
D
ADDED RING TAB FOR PLATING;
REVISED NOTES FOR TABS AND
REMOVAL OF RING TAB
8/5/2013
THIRD ANGLE PROJ.
D
WIS GEN 1 ANTENNA BELT PACK TX
10-0318
SHEET:
1 OF 1
DATE
02/18/13
SHEET SIZE
A
APPROVALS
PROPRIETARY NOTE:
32
MAT
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN INCHES 1.
TOLERANCES: .XXX
.010 .XX .015 ANGLES 3° 2.
REMOVE BURRS AND SHARP EDGES .015 MAX. 3.
NORMALITY, SQUARENESS AND PARALLELISM OF 4.
MACHINED SURFACES .004
MACHINED DIAMETER ON A COMMON CENTERLINE 5.
CONCENTRIC WITHIN .002 T.I.R.
ALL MACHINED SURFACES 6.
.031" COPPER STRIP
This document and the information it contains
are proprietary and may not be used,
assigned, or copied without the written
consent of Radio Design Group
DRAWN BY
D. BULLOCK
SCALE:
FIN
SEE NOTE 7
APPROVED
8925 Rogue River Highway, Grants Pass, OR 97527-4377
RADIO DESIGN GROUP, INC.
1:1
DWG NO.
CHECKED
7.
FINISH: SILVER PLATE PER QQ-S-365D, Type II, Grade A ( DO NOT USE NICKEL IN THE PLATING PROCESS)
8. CORNERS MUST NOT BE ETCHED FOR BENDING - ADVERSELY AFFECTS RF PERFORMANCE
9. REMOVE RING TAB AFTER PLATING
10. RECESSED TABS PERMITTED IN LOCATIONS AS MARKED (WILL BE SOLDERED AT THESE LOCATIONS)