User Manual

117
SPECTRALIS 2
Pressing [OCT DOWN] decreases the frequency of all oscillators by one octave
(12 halftones down).
Pressing [OCT UP] increases the frequency of all oscillators by one octave
(12 haltones up).
Press the Osc Detune encoder button to enter the oscillator pitch menu.
The first menu page of the pitch menu sets the finetune of the oscillators. If one
decreases the fine pitch up to the next halftone, the coarse tune parameter gets
affected and the fine tune parameter starts at the lowest setting again.
1/4:VCO 1-4 Fine Tune
ˆOsc1:0 ˆOsc2:0 ˆOsc3:0 ˆOsc4:0
„OscX“ - Finetune value control.
By pressing any of the display encoder buttons 1 - 4, one enters the submenu
for the fine tune modulation.
^ 1/8:VCO1 Pitch LFO
LWve:0 LRte:13 LDpt:0
Each oscillator has it’s own independent pitch LFO.
„LWve“ - (LFO Wave) changes the waveform shape of the LFO.
„LRte“ - (LFO - Rate) changes the rate of the pitch LFO.
„LDpt“ - (LFO Depth) changes the depth of the pitch LFO.
^ 2/8:VCO1 Pitch Modulation
Src1:None Dph1:0 Src2:None Dph:0
Additionally the pitch of an oscillator can be modulated by selectable
modulation sources.
„Src1“, „Src2“ - (Modulation source) selects the modulation source for
the additional pitch modulation.
„Dph1“, „Dph2“ - (Modulation depth) controls the modulation depth of
the selected additional modulation source.
The following modulation sources are available
MLFO1-4 - Master LFO 1-4
MMLFO - Multimode Filter cutoff LFO
LPLFO - Lowpass Filter cutoff LFO
VLFO1-4 - VCO frequency LFO 1-4
Hybrid Synthesizer reference: Oscillator pitch menu