Specifications

46 Chapter 2 Logic Control—Details
• Pressing a V-SELECT while the SHIFT button is held down mute/unmutes the
Instrument
• Pressing a MUTE button while the SHIFT button is held down mute/unmutes the
Instrument
Instrument Edit View
• The Mode Display will show
In.
• Dependent on the NAME/VALUE button, the LCD changes in the following ways:
• Name—The upper LCD row shows the track’s name, instrument name, current
parameter page and total number of parameter pages. The lower LCD row shows
the name of the parameter edited with the V-POT below it.
• Value—The upper LCD row shows the name of the parameter edited with the V-
POT
below it. The lower LCD row shows the current value of the parameter edited
with the V-POT. If there is sufficient space left, the unit is appended.
• Turning the V-POTs changes the corresponding parameter
• Pressing a V-SELECT sets the parameter to its default value, except where the
parameter only has two values (on/off, for example). In this case, pressing the V-
SELECT
toggles between these values.
Compatibility
The comments in section Compatibility section on page 44 also apply to software
instruments.
Fader Bank Zone
This area of the Logic Control surface contains six buttons.
Bank Left/Right
Moves up or down by “banks” of channels/tracks. To quickly explain, a single Logic
Control is only capable of viewing 8 tracks at a time in either Global or Mixer View. To
see, and edit or mix more tracks, simply press the RIGHT/LEFT BANK buttons to switch
between tracks 1—8, 9—16, 17—24 a. s. o.
The BANK button pair shifts the view section by the number of channels in the Control
Surface Group. E. g. if you have a Logic Control and two Logic Control XT units, the view
shifts by 24 channels.