User's Manual

be required. However, the OEM integrator is still responsible for testing their end product

for any additional compliance requirements required with the module installed (for

example, digital device emissions, PC peripheral requirements, etc).

IMPORTANT NOTE: In the event that these conditions can not be met (for example

certain laptop configurations or co-location with another transmitter), then the FCC

authorization is no longer considered valid and the FCC ID can not be used on the final

product. In these circumstances, the OEM integrator will be responsible for re-evaluating

the end product (including the transmitter) and obtaining a separate FCC authorization.

Host (End Product) Labeling Requirements

To maintain compliance, the end product hosting the WiFiHU2S module must be

properly labeled to identify that this module is installed. This transmitter module is

authorized only when used in devices where the antenna is installed such that 20 cm is

maintained between the antenna and users. The final end product must have a label

located in a visible area with the following information:

The XXXXXXX reflects the correct model installed into the host equipment: The

models are WiFiHU2-a, WiFiHU2-c, WiFiHU2-a-1-NE, or WiFiHU2-c-1-NE

The label shall be securely affixed to a permanently attached part of the device, in a

location where it is visible or easily accessible to the user, and shall not be readily

detachable. The label shall be sufficiently durable to remain fully legible and intact on the

device in all normal conditions of use throughout the device’s expected lifetime. These

requirements may be met either by a separate label or nameplate permanently attached to

the device or by permanently imprinting or impressing the label directly onto the device.

The label text shall be legible without the aid of magnification, but is not required to be

larger than 8-point font size.

End User Information: This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. End users must follow the specific

operating instructions for satisfying RF Exposure compliance. The end user should NOT

be provided any instructions on how to remove or install the device. The users manual for

end users must include the following information in a prominent location.

Contains Transmitter

Module

Model: XXXXXXX

FCC ID: K7T- WIFIHU2

IC: 2377A- WIFIHU2