User's Manual

\Vn Extended Result Code – This command defines the attributes of the CONNECT

result code.

\V0 Connect result code will be appended with the DTE (Serial Port Host

Interface) Speed. For example “ CONNECT 9600” indicates the Serial

Interface is 9600bps.

\V1 Connect result code will reflect the RF data link speed. For example

“ CONNECT RF9600” indicates that the RF data link is at 9600.

&W Save current configuration – Issuing AT&W command will save current DTE

speed, specific AT commands and S registers into the modules NVRAM (Non

Volatile Random Access Memory) This means the module will revert to the

saved settings whenever the module is powered Off/On or reset with either the

ATZ command or Pin 16 is toggled. The following command and registers can be

stored. This command also saves the DTE speed that the AT&W command is

issued.

Storable Commands: \Tn, %An, %Fn, %Mn, %Sn, &Dn, Bn, \In

Storable S Registers: S0, S7, S18

Z Soft reset - This command will cause the module to reset the AT commands to the

values stored in the modules memory (See the &W command).