User's Manual

RW8200 Special atbp Command Set

a: ip address

atbp a 192 168 1 1 (space for each arguments)

c: country setting

atbp c 123 (see country table for different country setting)

d: dhcp enable

atbp d 0 (disable dhcp, other value will turn on dhcp)

g: gateway address

atbp g 192 168 1 0 (space for each arguments)

i: ap ssid

atbp i RADICOM (SSID is RADICOM)

m: address mask

atbp m 255 255 255 0 (space for each arguments)

p: paraphrase

atbp p 12345678 (12345678 is the key)

s: security type

atbp s 0 (0: no security)

t: tcp listen tx port

atbp t 3490 (for tcp tx port 3490)

u: tcplisten rx port

atbp u 3490 (for tcp rx port 3490)

o: save current settings

atbp o (save current settings into flash which will be loaded

starting next power reset)

z: load and apply settings

atbp z (load and apply settings stored in flash)

f: factory default

atbp f (Use factory default settings)

v: display setting

atbp v (display setting)

b: baud rate setting

atbp b n (n=0: 9600; 1: 19200; 2: 38400; 3: 57600; 4: 115200; 5:

230400; 6: 460800; 7: 921600)